HEIDENHAIN iTNC 530 HSCI - Tolerance Limit

748 HEIDENHAIN Technical Manual iTNC 530 HSCI
Example of a kinematic description with a B head and optional C table:
SUBFILE1:
Tolerance limit In MP6600 you can enter the maximum permissible amount of change for the
cycles used in KinematicsOpt. The amount of change prevents you from
accidentally changing the machine kinematics too much with KinematicsOpt.
Whenever optimization requires a change greater than what is permitted in
MP6600, a message appears and the change must be confirmed with NC
start.
NR KEY AXIS COORD COORD (compensations)
0 TOOLFILE --> No changes
2 CMO --> No changes
3 Trans X +0.01 --> +0.006
4 Trans Y +0 --> +0
6 Trans Z +250.02 --> +250.034
7 MachAxis B --> No changes
8 MachAxis Z --> No changes
9 MachAxis Y --> No changes
10 MachAxis X --> No changes
11 SUBFILE1 X --> No changes
12 Trans X +0 --> No changes
[END]
NR KEY AXIS COORD COORD (compensations)
0 Trans Z -655.045 --> No changes
1 Trans X +440.01 --> +440.006
2 Trans Y +250.02 --> +250.034
3 CMO --> No changes
4 MachAxis C --> No changes
5 CMO --> No changes
[END]