Setting in MP2190 made and MP2160 = 1
(start value)
Is the actual acceleration
continuous and is the final shaft
speed reached?
MP2160 = 1 (13)
End
YES
Reduction of the ramp gradient
Measurement of the actual
magnetizing current
No
Setting the ramp gradient
Alternative
Actual magnetizing current to
high (max Id > 0.9 Imax)? (14)
No
MP2160 = 9 (15)
Is the actual acceleration
continuous and is the final shaft
speed reached?
MP2160 = 9 (16)
End
YES
Reduction of the ramp gradient
No
Install a larger power module
Alternative
YES
To Next Page
Loading...
