954 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP3411.0-7 Ramp gradient of the spindle with M03 and M04 for gear
ranges 1 to 8
Input: Analog axes: 0 to 1.999 [V/ms]
Digital axes: 0 to 1.999 [(1000 min
–1
)/ms]
MP3415 Overshoot behavior of the spindle with M03, M04 and M05
Input: 0 to 1000 [ms]
MP3415.0 With M03, M04 and M05
MP3415.1 For spindle orientation
MP3415.2 For tapping
MP3415.3 For rigid tapping
MP3412 Multiplication factor for MP3411.x
Input: 0.000 to 1.999
MP3412.0 With M05
MP3412.1 With spindle orientation
MP3412.2 For tapping with floating tap holder
MP3412.3 For rigid tapping
MP7440 Output of M functions
Input: Bit 7 – Internal spindle status of the geometry
0: With M00 the internal spindle status switches to M05
1: With M00 the internal spindle status does not switch to M05
Set Reset
M4001 Nominal speed command signal of
the spindle not in the ramp
NC NC
M4002 Nominal speed value = 0 NC NC
To Next Page
Loading...
