July 2013 6.12 Spindle 957
Direction of spindle
rotation
With MP3130, define the polarity of the nominal speed value
In MP3140, enter the counting direction of the position encoder signals.
As soon as you set M4005 for M03, or M4006 for M04, the nominal speed
value is output. With M4007 for M05, the nominal speed value zero is output
(spindle stop).
M4005 to M4007 also controls the miscellaneous functions in the status
window.
If more than one marker is set at the same time, the error message PLC:
M4005, M4006, M4007 INCORRECT appears.
With M4014 you can reverse the direction of rotation, in order to adjust the
transmission for horizontal or vertical spindles, for example. The polarity of the
nominal spindle speed is inverted.
M4019 reverses the counting direction of the spindle.
MP3130 Polarity of the nominal spindle speed
Input: 0: M03 positive, M04 negative
1: M03 negative, M04 positive
2: M03 and M04 positive
4: M03 and M04 negative
MP3140 Counting direction of spindle position encoder output
signals
Input: 0: Positive counting direction with M03
1: Negative counting direction with M03
Set Reset
M4005 Status display and nominal speed
value output for M03
PLC PLC
M4006 Status display and nominal speed
value output for M04
PLC PLC
M4007 Status display M05 and spindle stop PLC PLC
M4014 Reverse the direction of spindle
rotation
PLC PLC
M4019 Reverse the counting direction of the
position encoder on the spindle
PLC PLC
To Next Page
Loading...
