HEIDENHAIN iTNC 530 HSCI - Tapping with Floating Tap Holder and Coded Spindle-Speed Output

976 HEIDENHAIN Technical Manual iTNC 530 HSCI
6.12.8 Tapping with floating tap holder and coded spindle-speed output
The dwell time for rotational direction reversal (MP7120.0) and the
programmed dwell time have the same effect as the nominal speed value
output.
The following diagram shows the time sequence of the cycle:
MP7120.1 Advanced switching time of the spindle during tapping
with coded spindle-speed output
Input: 0 to 65.535 [s]
0
F
0
S
M03
M05
M04
M4092
M4030
MP7120.0
MP7120.1
Dwell time from
CYCL DEF 2.3