HEIDENHAIN iTNC 530 HSCI - Page 978

978 HEIDENHAIN Technical Manual iTNC 530 HSCI
M4031 and M4030 are set while the cycle runs.
While Cycle 17 is running, the positioning window from MP7150 applies to the
tool axis:
 Enter a value in MP7150 less than or equal to MP1030.x.
Define the acceleration and braking process of the spindle during rigid tapping:
 In MP3412.3 enter a multiplier for MP3411.x.
 With MP3415.3, define the overshoot behavior of the spindle.
 With MP7130, define the run-in behavior of the spindle.
0
F
0
S
M05
M4092
M4030
M4031
M4012
Positioning window
reached (MP7150)
Ramp from
MP3412.3
Oriented stop
Oriented stop
Start of
cycle
End of
cycle
S
MP3412.3
MP3415.3
MP3412.3
MP7130