16 – 220 HEIDENHAIN Service Manual iTNC 530 HSCI
If you press the MOD key while the machine is on, you can see whether a service pack is active.
In this case you find the letters SP followed by the version number after the ID number of the
NC software (e.g., 606420 01 SP5).
Export restrictions As iTNC 530 HSCI features more than 4 axes interpolating with each other (contouring with calculation
of more than 4 axes), it is subject to export licensing.
An export license is thus required for:
The NC software of the iTNC 530 HSCI
Associated service packs
16.2 Preparations
Who provides the
new service pack?
The machine manufacturer receives the service pack directly from HEIDENHAIN.
Service engineers and end users receive the new service pack from the machine manufacturer.
Preparing the
machine tool
8 Move the machine to home position (axes, tool changer, tilting head, etc.)
Ask the machine operator!
8 Press EMERGENCY STOP.
8 Restart the control, do not acknowledge the Power interrupted message.
Contact your OEM, if you suspect conflicts!
NC software and service packs that are on your laptop or a USB flash drive also require an export
permit!
HEIDENHAIN recommends backing up the control data before loading a service pack.
--> See ”Backup on an external data medium” on page 14 – 202.
To Next Page
Loading...
