HEIDENHAIN iTNC 530 HSCI - Page 417

26 – 418 HEIDENHAIN Service Manual iTNC 530 HSCI
TT with signal transmission via cable (e.g. TT 140)
 This touch probe is used to measure tools (length, radius, individual teeth).
 Tools can be examined for breakage.
 Tool wear can be determined.
TL laser
touch probe
Laser probe system (e.g., TL Micro 150) for tool measurement
 This laser system is used to measure tools (e.g., length, radius, individual teeth).
 Tools can be examined for breakage.
 Tool wear can be determined.
DANGER
Laser radiation! Do not stare into beam! Laser class 2.