February 2012 26 – 419
Infrared
transmission
360° range:
The LEDs and receiver modules for infrared transmission are evenly distributed on the circumference
of the touch probe. This ensures a 360° transmission range for reliable reception without previous
spindle orientation.
Beam angle:
To adapt the touch probes to varying machine designs, the touch probes are available with horizontal
transmission elevations of 0° or +30°.
Touch probe
cycles
By means of touch probe cycles ...
Datums can be set in manual and automatic mode.
Workpiece misalignment can be compensated manually and automatically.
Workpieces can be measured automatically.
Tools can be measured automatically.
Touch probe systems can be calibrated.
Touch probe
signals
Touch probes are powered and evaluated via the PLB 62xx system module or the UEC 11x
controller unit.
The information is transferred to the control via the HSCI bus.
Further
information
You will find further information on touch probes in the…
iTNC 530 HSCI User's Manual
corresponding mounting instructions
brochure 3-D Touch Probes for Machine Tools
These documents can be downloaded from the HEIDENHAIN website (www.heidenhain.de).
To Next Page
Loading...
