February 2012 26 – 425
Functional test by
means of DriveDiag
8 Switch on the machine.
8 Insert the touch probe.
8 Press the EMERGENCY STOP button as a precaution.
8 Call DriveDiag. --> See ”DriveDiag” on page 9 – 91.
8 Open the following page:
8 Check the lamp at TS touch probe ready (X12).
When the touch probe is ready, the lamp shines green.
8 Deflect the stylus by hand.
8 Check the lamp at trigger signal of TS touch probe (X12).
When the stylus is deflected, the lamp shines green.
8 You can also observe the lamp at TS touch probe battery (X12).
If the battery capacity is sufficient, this lamp shines green.
With touch probe systems with cable, this lamp shines red.
Ask the machine manufacturer and observe the machine manufacturers's safety precautions
(set-up mode, etc.)!
To Next Page
Loading...
