27 – 452 HEIDENHAIN Service Manual iTNC 530 HSCI
Currently, the following NC software versions may be installed on an iTNC 530 HSCI:
As the NC software of the iTNC 530 HSCI is subject to export licensing, HEIDENHAIN can also supply
a special export version (until now all odd-numbered NC software versions).
HEIDENHAIN releases a new program number for the NC software whenever it introduces extensive
new functions.
PLC software
Feature Content
Level
When a new NC software version is released, error fixes and improvements in functions are managed
separately.
When the NC software is updated to a new version, only the included error fixes will initially be
effective.
If the new features of this NC software version are also required, they can be enabled by entering
a code number. --> Ask the machine manufacturer!
DSP software
Current controller
software
Hardware Standard SW Export SW Comment
Single-processor 606 420-xx 340 421-xx iTNC 530 HSCI and HeROS 5
BASIC 54 HSCI Random character sequence which the machine manufacturer uses to
identify his PLC software
L4 "L" is the abbreviation of "level"; "1" stands for the "feature content".
340542 Program number of DSP software
03.3 Version of the DSP software
The DSP software is the operating system for the digital signal processors (DSP) that are
responsible for the speed control of digital axes/spindles:
DSP1: Software for the main controller board
DSP2: Software for the add. controller board
1.02.11 Program number of current controller software
9:35 Date and time of installation
The ICTL software is the operating system for the digital signal processors (DSP) that are
responsible for the speed control of digital axes/spindles:
ICTL1: Software for the main controller board
ICTL2: Software for the add. controller board
To Next Page
Loading...
