29 – 516 HEIDENHAIN Service Manual iTNC 530 HSCI
Export
restrictions
If an iTNC 530 HSCI operates with an NC software where more than four axes can interpolate
with each other, (contouring with calculation of more than 4 axes), it is subject to export licensing.
The NC software for path interpolation is stored on the data medium.
Export licenses are thus required for:
The NC software of iTNC 530 HSCI for interpolation of more than four axes
Associated service packs
The HDR (Hard Disk Removable) on which this NC software is stored
The SSDR (Solid State Disk Removable) on which this NC software is stored
The SIK (on which the NC software version of iTNC 530 HSCI is stored)
High-accuracy and high-resolution encoders may also require an export license.
NC software update An NC software update is performed by the machine manufacturer or in coordination with him.
The PLC program, the machine parameters or the data in the PLC partition may also be updated,
according to the OEM’s specific instructions.
Contact your OEM, if you suspect conflicts!
NC software and service packs for path interpolation of more than four axes that are on your laptop
or a USB flash drive also require an export permit!
The HEIDENHAIN NC software for iTNC 530 HSCI must be released by the OEM for the
respective machine!
The NC software update is described in the iTNC 530 HSCI Technical Manual which is available to
the machine tool builder.
To Next Page
Loading...
