HEIDENHAIN iTNC 530 HSCI - Page 539

29 – 540 HEIDENHAIN Service Manual iTNC 530 HSCI
Adapting
MPNAME.MP
Now the control may require entries in MPNAME.MP.
8 Do not enter any data here. With the MOD key, you can open the code number window, set date
and time, set up the Ethernet interface and load the appropriate backup for the machine. Continue
as described!
Defining the NC
software version
Check the currently active NC software version:
8 Call the code number window.
Note
If you require a different software version, load it now. --> Contact your machine tool builder.
Open the program manager and delete the incomplete MPNAME.MP file. --> A suitable
MPNAME.MP will be created automatically. Only now can you exit the Machine parameter
programming mode; the Setup key word is accepted.