HEIDENHAIN iTNC 530 HSCI - Exchanging other HEIDENHAIN components

February 2012 29 – 553
29.12 Exchanging HEIDENHAIN interface boards in the SIMODRIVE system
Version with
D-sub connector
HEIDENHAIN interface boards for the SIMODRIVE system in the version with D-Sub connector are
available with or without metallic isolation of HEIDENHAIN PWM signals to the Siemens interface.
Interface boards without metallic isolation are identified
as follows:
 On the front panel, there are the LEDs NB (not ready) and
IF (pulse release).
 There is no grounding screw on the front panel.
 There is no transformer on the board.
 These boards have the ID numbers 291070-01,
324952-01, 02, 03 and 10 without index A.
Attention
The terminal X131 of the Siemens E/R module of boards without metallic isolation must not
be connected to the central signal ground of the machine!
Note
The HEIDENHAIN interface boards of the first generation were produced without metallic
isolation.