HEIDENHAIN iTNC 530 HSCI - Page 577

31 – 578 HEIDENHAIN Service Manual iTNC 530 HSCI
Restoring
original
settings
When you have finished error diagnosis or certain tests at the machine, you will normally restore the
original settings.
8 You are in the Machine parameter programming mode.
8 Call the program management.
8 Place the cursor on the original MP list.
8 Load this file into the editor.
8 Press the END key. (The iTNC 530 HSCI activates the selected original MP file and
performs a reset, if necessary.)
Figure: Active MP list in the program manager
Note
In the program management, the active MP file is distinguished by the letter M in the status
column.