HEIDENHAIN iTNC 530 HSCI - Page 585

31 – 586 HEIDENHAIN Service Manual iTNC 530 HSCI
MP1090 Maximum permissible jerk on the tool path
Input: 0: Not active
0.0 to 9999.9 [m/s
3
or °/s
3
]
PLC
RUN
MP1090.0 For movements not at rapid traverse or feed rate < MP1092
MP1090.1 For movements at rapid traverse or feed rate > MP1092
MP1092 Feed rate threshold for MP1085.x and MP1086.x
Input: 1 to 300 000 [mm/min] (previous behavior)
0: Not active
PLC
RUN
MP1094 HSC filter (no longer recommended with HSCI, improved nominal position value filters as
of MP12xx)
Input: 0: HSC filter inactive
0.1 to 166.0: Cutoff frequency for HSC filter
Only through
MPMODE =
340422 in
OEM.SYS
MP1095 Nominal position value filter (no longer recommended with HSCI, improved nominal
position value filters as of MP12xx)
Input: 0: Single filter
1: Double filter
PLC
RUN
Only through
MPMODE =
340422 in
OEM.SYS
MP1095.0 In the Program Run Full Sequence, Program Run Single Block, and Positioning With
Manual Data Input operating modes
MP1095.1 In the Manual, Handwheel, Jog Increment and Pass Over Reference Point operating
modes
MP1096 Tolerance for contour transitions at corners (no longer recommended with HSCI, improved
nominal position value filters as of MP12xx)
Input: 0: No nominal position value filter
0.001 to 3.000 [mm]
PLC
RUN
Only through
MPMODE =
340422 in
OEM.SYS
MP1096.0 With machining feed rate
MP1096.1 With rapid traverse
MP1097.x Max. permissible axis-specific jerk (single filter / HSC filter) (no longer recommended with
HSCI, improved nominal position value filters as of MP12xx)
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
PLC
RUN
Only through
MPMODE =
340422 in
OEM.SYS
MP1098.x Max. permissible axis-specific jerk (double filter / HSC filter) (no longer recommended with
HSCI, improved nominal position value filters as of MP12xx)
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
PLC
RUN
Only through
MPMODE =
340422 in
OEM.SYS
MP1099 Minimum filter order (no longer recommended with HSCI, improved nominal position
value filters as of MP12xx)
Input: 0 to 20
PLC
RUN
Only through
MPMODE =
340422 in
OEM.SYS
MP1099.0 Minimum filter order for single filter (MP1095 = 0)
MP1099.1 Minimum filter order for double filter (MP1095 = 1)
MP1110.x Standstill monitoring
Input: 0.0010 to 30.0000 [mm]
PLC
RUN
MP1120.x Standstill monitoring when determining the field angle
Input: 0.0000 to 300.0000 [mm] or [°]
PLC
RUN
MP Function and input Software
version and
behavior