HEIDENHAIN iTNC 530 HSCI - Error Localization by Process of Interchange

February 2012 6 – 61
6.5 Error localization by process of interchange
For checking machine-tool components that are available more than once (servo amplifiers, motors,
expansion boards, etc.) the "interchange method" can be used.
To do this, interfaces or identical devices are interchanged in order to find out, whether the error
"moves".
Example:
Interchange
possibilities on
iTNC 530 HSCI
with CC 61xx
Example:
Interchange
possibilities on
iTNC 530 HSCI
with UEC 11x