February 2012 31 – 601
MP2900.x Tensioning torque between master and slave for master-slave torque control
(entry for the slave axis)
Input: –100.00 to +100.00 [Nm]
PLC
MP2910.x P factor of the torque controller for master-slave torque control (entry for the slave axis)
Input: 0.00 to 999.99 [1/(Nm ⋅ min)]
PLC
MP2912.x Setting for master-slave torque control
Input: 0: The output of the torque adjustment controller (= speed
compensation value) is distributed evenly to master and slave.
1: The output of the torque-adjustment controller (= speed
compensation value) is only distributed to the slave.
PLC
MP Function and input Software
version and
behavior
To Next Page
Loading...
