HEIDENHAIN iTNC 530 HSCI - Page 611

31 – 612 HEIDENHAIN Service Manual iTNC 530 HSCI
MP6505 Probing direction for tool radius measurement for 3 traverse ranges
Input: 0: Positive probing direction of the angle reference axis (0° axis)
1: Positive probing direction in the +90° axis
2: Negative probing direction in the angle reference axis (0° axis)
3: Negative probing direction in the +90° axis
PLC
RUN
CN123
MP6505.0 Traverse range 1
MP6505.1 Traverse range 2
MP6505.2 Traverse range 3
MP6507 Calculation of the probing feed rate
Input: 0: Calculation of the probing feed rate with constant tolerance
1: Calculation of the probing feed rate with variable tolerance
2: Constant probing feed rate
PLC
RUN
CN123
MP6510 Maximum permissible measuring error for tool measurement with rotating tool
Input: 0.002 to 0.999 [mm]
PLC
RUN
CN123
MP6510.0 First measurement error
MP6510.1 Second measurement error
MP6520 Probing feed rate for tool measurement with non-rotating tool
Input: 1 to 10 000 [mm/min]
PLC
RUN
CN123
MP6530 Distance from the tool end to the top of the probe contact during tool radius measurement
for 3 traverse ranges
Input: 0.001 to 99.9999 [mm]
PLC
RUN
CN123
MP6530.0 Traverse range 1
MP6530.1 Traverse range 2
MP6530.2 Traverse range 3
MP6531 Diameter or edge length of the TT 130 probe contact for 3 traverse ranges
Input: 0.001 to 99.9999 [mm]
PLC
RUN
MP6531.0 Traverse range 1
MP6531.1 Traverse range 2
MP6531.2 Traverse range 3
MP6540 Safety zone around the probe contact of the TT 130 for pre-positioning
Input: 0.001 to 99 999.9999 [mm]
PLC
RUN
CN123
MP6540.0 Safety clearance in tool axis direction
MP6540.1 Safety clearance in the plane perpendicular to the tool axis
MP6550 Rapid traverse in probing cycle for TT 130
Input: 10 to 1 000 000 [mm/min]
PLC
RUN
CN123
MP6560 M function for spindle orientation during individual tooth measurement
Input: –1: Spindle orientation directly by NC
0: Function inactive
1 to 999: Number of the M function for spindle orientation by PLC
PLC
RUN
CN123
MP6562 M function before and after tool measurement cycle (TT cycle)
Input: –1: Function inactive
0 to 999: Number of the M function
349 490-06
PLC
RUN
CN123
MP6562.0 M function before the cycle start
MP6562.1 M function after cycle end
MP Function and input Software
version and
behavior