31 – 628 HEIDENHAIN Service Manual iTNC 530 HSCI
MP7470 *Maximum contouring tool feed rate at 100% override
Input: 0 to 300 000 [mm/min]
0: No limitation
PLC
RUN
CN123
MP7471 Maximum velocity of the principal axes during compensating movements through
M128 or TCPM
Input: 0 to 300 000 [mm/min]
PLC
RUN
CN123
MP7475 Reference for datum table
Input: 0: Reference is workpiece datum
1: Reference is machine datum (MP960.x)
PLC
RUN
CN123
MP7480 Output of the tool or pocket number PLC
RUN
MP7480.0 With TOOL CALL block
Input: 0: No output
1: Tool number output only when tool number changes
2: Tool number output for every TOOL CALL block
3: Pocket number and tool number output only when tool number
changes
4: Output of the pocket number and tool number for every TOOL CALL
block
5: Pocket number and tool number output only when tool number
changes. Pocket table is not changed.
6: Pocket number and tool number output for every TOOL CALL block.
Pocket table is not changed.
MP7480.1 With TOOL DEF block
Input: 0: No output
1: Tool number output only when tool number changes
2: Tool number output for every TOOL DEF block
3: Pocket number and tool number output only when tool number
changes
4: Pocket number and tool number output for every TOOL DEF block
MP7481.x Sequence for new and returned tool when changing tools
Format: %xxxxxxxx
0: First, output the pocket of the tool to be returned
1: First, output the pocket of the new tool
Input: Bit 0: New tool from magazine 1
Bit 1: New tool from magazine 2
Bit 2: New tool from magazine 3
Bit 3: New tool from magazine 4
Bit 4: New tool from magazine 5
Bit 5: New tool from magazine 6
Bit 6: New tool from magazine 7
Bit 7: New tool from magazine 8
PLC
RUN
MP7481.0 Tool from magazine 1 to be returned
MP7481.1 Tool from magazine 2 to be returned
MP7481.2 Tool from magazine 3 to be returned
MP7481.3 Tool from magazine 4 to be returned
MP7481.4 Tool from magazine 5 to be returned
MP7481.5 Tool from magazine 6 to be returned
MP7481.6 Tool from magazine 7 to be returned
MP7481.7 Tool from magazine 8 to be returned
MP Function and input Software
version and
behavior
To Next Page
Loading...
