February 2012 31 – 629
MP7482 Pocket coding of the tool magazines
Format: %xxxxxxxx
0: Variable pocket coding
1: Fixed pocket coding
Input: Bit 0: Magazine 1
Bit 1: Magazine 2
Bit 2: Magazine 3
Bit 3: Magazine 4
Bit 4: Magazine 5
Bit 5: Magazine 6
Bit 6: Magazine 7
Bit 7: Magazine 8
PLC
RUN
MP7483 Tool name/number for TOOL CALL / TOOL DEF
Input: 0: Names and numbers are permitted (as before)
1: Only names are permitted
2: Only numbers are permitted
MP7484.x Search sequence in tool magazines
Input: 0 to 7 [index from MP7261]
-1: Abort
MP7485 Add usage time for tool selection
Input: 0 to 100 [%]
Default setting: 10
MP7490 Functions for traverse ranges
Format: %xxxx
Input: Bit 0 –
0: Display one traverse range with MOD
1: Display three traverse ranges with MOD
Bit 1 –
0: Each traverse range has its own datum (and 3 memories for the
positions of the swivel head)
1: One datum for all traverse ranges
Bit 2 – Calibration data: Touch probe for workpiece measurement:
0: One set of calibration data for all traverse ranges
1: Every traverse range has its own set of calibration data
Bit 3 – Calibration data: Touch probe for tool measurement:
0: One set of calibration data for all traverse ranges
1: Every traverse range has its own set of calibration data
PLC
RUN
MP7492.x Number of axis in which the same datum is to be set during Datum Setting (with active
preset table)
Input: 0 to 17
–1: Do not set a datum
PLC
RUN
MP7492.0
MP7492.17
Datum set in the first axis
to
Datum set in the 18th axis
MP7493 Maximum deviation of the current tool orientation relative to the tool axis when setting a
reference point with M114
Input: 0.0000 to 30.0000 [degrees]
Default: 0.005
PLC
RUN
MP7494 Axes for which an exact stop is to occur after positioning
Format: %xxxxxxxxxxxxxxxxxx
Input: Bits 0 to 17 represent axes 1 to 18
0: No exact stop
1: Exact stop
PLC
RUN
MP7500
(is set via the
kinematics
table)
Reserved
MP Function and input Software
version and
behavior
To Next Page
Loading...
