HEIDENHAIN iTNC 530 HSCI - Log

8 – 80 HEIDENHAIN Service Manual iTNC 530 HSCI
8.2 Calling the log
8 Enter the code number LOGBOOK. --> See ”Code numbers” on page 3 – 17.
The following window appears:
8 If you wish, you can change the path and the file name here.
(Default setting: TNC:\LOGBOOK.A)
8 You can also define the starting point and the end point for reading out the log.
8 Then start reading out the log by pressing the EXECUTE soft key.
An ASCII file with the log entries is generated and displayed on the screen.
Note
Ensure correct spelling when making any changes in the log window.