HEIDENHAIN ITNC 530 - Page 24

24
1.1 Introduction
Differences in miscellaneous functions M concerning older
software versions of the iTNC 530
Meaning of the symbols used in the table:
Differences in Q parameter programming concerning the TNC 4xx
Meaning of the symbols used in the table:
x Function not available in this software version
þ Function available in this software version
M function
iTNC 530, software
version
340 422 340 420
M150 xx
x Function not available in this software version
þ Function available in this software version
Function TNC 426/ TNC 430, software version TNC 410
280 476 280 474 280 472 280 470 280 462 286 060
Formula entry: SGN xxxxxþ
Formula entry: % xxxxxx
FN16 þþþþþx
FN20 þþþxxx
FN23 þþþxxx
FN24 þþþxxx
FN25 þþþxxx
FN26 þþxxxx
FN27 þþxxxx
FN28 þþxxxx
Contour formula QC... xxxxxx
String formula QS... xxxxxx
Local parameters QL... xxxxxx
Nonvolatile parameters QR... xxxxxx