HEIDENHAIN iTNC 530 Programming Station 45
2.2 Connecting the Programming Station
Installing the programming station software
U Place the programming station CD in the CD-ROM drive
U The CD browser starts automatically if your CD-ROM drive has been
appropriately configured. If Autostart is not active, run the
<Start.exe> file
U Choose the language to be used for the CD navigation
U Select <Install software>
U Select <Install iTNC programming station> in order to start the
installation program
U Follow the installation program instructions
Note that the following files are normally overwritten
during installation of an update:
Configuration file OEM.SYS
Machine parameter file DEMO.MP
All example NC programs in the TNC:\DEMO directory
Should you have made any changes in one of these files,
make a backup copy before installation, or rename the
files.
When installing the iTNC530 programming station for the
first time, you can decide whether the HEIDENHAIN basic
PLC program for the programming station is to be installed
as well. Select the setup type User and then Basic PLC
Program or Standard (User) (see “Working with the
HEIDENHAIN basic PLC program” on page 50).
You can install this programming station version on your
PC even if another version is already installed on your PC,
but you cannot start both versions at the same time.
To Next Page
Loading...
