July 2010 11 – 141
Markers influenceable by machine parameters
Tool change
M 4222 Error from PET table with EM. STOP active NC NC
M 4223 Error from PET table with NC Cancel active NC NC 340 422-10,
340 480-10
M 4225 Activate alternative error reaction 340 49x-04
M 4227 PLC error message with priority 0 (error) NC NC 340 422-10,
340 480-10
M 4228 PLC error message with priority 1 (warning) NC NC 340 422-10,
340 480-10
M 4229 PLC error message with priority 2 (info) NC NC 340 422-10,
340 480-10
M 4230 NC start via LSV2 NC NC
M 4231 NC stop via LSV2 NC NC
Operand Description Set Reset As of SW vers.
Operand Description Set Reset As of SW vers.
M 4300 -
4315
Value from MP4310.0 NC NC
M 4316 -
4331
Value from MP4310.1 NC NC
M 4332 -
4347
Value from MP4310.2 NC NC
M 4348 -
4363
Value from MP4310.3 NC NC
M 4364 -
4379
Value from MP4310.4 NC NC
M 4380 -
4395
Value from MP4310.5 NC NC
M 4396 -
4411
Value from MP4310.6 NC NC
Operand Description Set Reset As of SW vers.
M 4520 Additional T code (P code) follows with TOOL CALL NC NC
M 4521 Tool number zero programmed NC NC
M 4522 Tool with pocket number programmed is in effect with
MP7480.0 = 3 or 4 and TOOL CALL
NC NC
M 4523 Tool without pocket number programmed is in effect with
MP7480.0 = 3 or 4 and TOOL CALL
NC NC
M 4524 Special tool called, TOOL CALL NC NC
M 4525 TOOL CALL after expiration of tool life NC NC
M 4526 -
4534
Axis 1 to axis 9 is the tool axis NC NC
M 4538 Geometry of the tool from W264 PLC NC
M 4539 Tool number highlighted in the status display PLC PLC
M 4540 Sequence of tool number or pocket number transfer (M4520 = 1) PLC PLC
M 4541 Special tool in original pocket in spite of variable pocket coding PLC PLC
M 4542 Do not update pocket number in the pocket table PLC PLC
M 4543 Tool life 1 expired (TIME1 in the tool table) NC NC/
PLC
M 4546 Tool life 2 expired (TIME2 in the tool table) NC NC/
PLC
M 4547 T and G strobes with TOOL CALL NC NC
To Next Page
Loading...
