HEIDENHAIN ITNC 530 - Page 142

11 – 142 HEIDENHAIN Service Manual iTNC 530
Additional keys
General Functions
Operand Description Set Reset As of SW vers.
M 4560 NC stop (0: stop) PLC PLC
M 4561 Rapid traverse PLC PLC
M 4562 Memory function for axis direction keys (MP7680 bit 0 = 1) PLC PLC
M 4563 Feed-rate enable for all axes PLC PLC
M 4564 NC start PLC PLC
Operand Description Set Reset As of SW vers.
M 4570 Unit of measure for transfer with FN19 NC NC
M 4571 Activation of decoded M-code transfer in M1900 to M1999 PLC PLC
M 4574 Select the traverse range (with M4575) PLC PLC
M 4575 Select the traverse range (with M4574) PLC PLC
M 4576 Locking the handwheel PLC PLC
M 4577 Disabled key was pressed NC PLC
M 4579 INCREMENT OFF/ON soft key NC NC
M 4580 Suppress EMERGENCY STOP, open all position control loops, NC stop PLC PLC
M 4581 Open all position control loops, NC stop, activate “Approach position” PLC PLC
M 4586 Enable AUTOSTART PLC NC/
PLC
M 4587 Rescind feed rate limit above F MAX PLC PLC
M 4589 Activate datum management via preset table NC NC
M 4590 Status fast PLC input from MP4130.2 NC PLC
M 4591 Status fast PLC input from MP4130.3 NC PLC
M 4592 Status fast PLC input from MP4130.4 NC PLC
M 4593 Status fast PLC input from MP4130.5 NC PLC
M 4600 Faulty internal communication between HeROS and Windows NC NC 340 480-06
M 4620 Enable LIFTOFF function PLC NC/
PLC
340 422-06,
340 480-06
M 4622 Delay NC macro with RESETINIT = from NCMACRO.SYS PLC PLC 340 422-10,
340 480-10
M 4623 Disable starting of DNC mode (LSV2 access) PLC PLC 340 49x-03
M 4624 Changed axis-traverse limits NC PLC 340 49x-04
M 4625 Disable NC axes when velocity semifeedforward control is active PLC PLC 340 49x-04
M 4626 Disable all key inputs of the TE keyboard unit, including the soft keys PLC PLC 340 49x-05
M 4660 HR 420 assumes control NC NC 340 422-09,
340 480-09
M 4661 NC start on HR 420 NC NC 340 422-09,
340 480-09
M 4662 NC stop on HR 420 NC NC 340 422-09,
340 480-09
M 4663 Rapid traverse key on HR 420 NC NC 340 422-09,
340 480-09
M 4664 Spindle start on HR 420 NC NC 340 422-09,
340 480-09
M 4665 Spindle stop on HR 420 NC NC 340 422-09,
340 480-09
M 4666 + key on HR 420 NC NC 340 422-09,
340 480-09
M 4667 Key – on HR 420 NC NC 340 422-09,
340 480-09