July 2010 13 – 179
TNCremoNT 8 Start the HEIDENHAIN data transfer program TNCremoNT.
8 Click this icon to open the configuration windows.
(Can also be called via Extras / Configuration ... .)
8 Now click on Connection and select Ethernet (TCP/IP).
8 Subsequently, click on Settings and enter the IP address of the control.
8 Check the transmission mode (BINARY-ASCII conversion). It should be set as follows:
8 Confirm with Apply and OK.
8 Click this icon. --> The connection is set up.
8 The TNCremo screen is split and the control's hard disk is shown in the lower half of the
screen.
If this does not work, check the connecting cable and the settings.
You can also try, whether pinging works. --> See next pages!
To Next Page
Loading...
