July 2010 13 – 183
Configuration of
the serial interface
on the iTNC
8 Call --> See “Interface configuration and assignment of mode” on page 13 – 206
8 Select the baud rate for the LSV/2 protocol.
You can select the highest possible baud rate. If there are transmission problems, you can
back on lower baud rates.
TNCremoNT
8 Start the HEIDENHAIN data transfer program TNCremoNT.
8 Click this icon to open the configuration windows.
(Can also be called via Extras / Configuration ... .)
8 Click now on Connection and select the LSV-2 (serial connection).
8 Then click on Settings and select the serial interface (e.g. COM1).
8 Activate automatic detection of the data transfer rate on connection setup. --> The baud rate
you have set on iTNC 530 is activated.
The iTNC 530 recognizes automatically when the LSV-2 protocol is used
(e.g., data transfer with TNCremoNT).
A setting in the line Operating mode is not necessary!
If you use a USB/RS -232-C adapter, automatic detection of the baud rate should not be
active. In this event set the transfer rate at the control and at the laptop to the same value.
To Next Page
Loading...
