July 2010 15 – 225
8 When the service pack has been successfully loaded, the following message is displayed:
8 Disconnect the USB stick and click OK or press the ENT key. --> The control restarts.
8 Check the NC software version incl. related service pack. --> Press the MOD key.
Functional test
8 Finally, check the machine functions!
If you have transferred the service pack from your laptop to the control (e.g., on
PLC:\servicepack), it can be deleted here again. Thus making space again on the hard disk.
The service pack is automatically archived on the SYS partition of the iTNC 530 and can be
called at any time.
To Next Page
Loading...
