July 2010 18 – 301
18.2.6 Possibilities with the integrated oscilloscope
As of NC software version 34049x-04 in combination with the CC 424 (B), the incremental
signals (A, B) can be recorded with the integrated oscilloscope.
Activation and operation --> See “Integrated Oscilloscope” on page 10 – 99.
Example for an oscilloscope recording of motor encoder signals:
8 Make the following settings:
8 Move the X-axis at very low speed in the manual mode.
8 Start the oscilloscope recording.
8 Stop recording.
8 Adapt the signals under consideration of the zero line.
8 Adapt the time axis for a more detailed representation.
Reference signals and EnDat signals cannot be displayed!
A phase angle measuring unit should be used for an accurate tracing of the signals
(e.g., PWM 9)!
To Next Page
Loading...
