28 – 530 HEIDENHAIN Service Manual iTNC 530
Replacement units
and spare parts
For replacement units and spare parts, ask your machine manufacturer!
This also applies for the NC software!
Please observe:
Always use original HEIDENHAIN components as replacements!
MC, HDR and drive assembly are normally equipped with the current NC software.
If you wish to keep the previously installed - older - NC software version, contact your OEM.
He can restore this version.
Please send the defective unit in its original packaging to your machine manufacturer or your
HEIDENHAIN agency.
Repair Many HEIDENHAIN units are not repaired on site but are exchanged or replaced.
These devices are exclusively repaired by HEIDENHAIN agencies. The devices are also updated
to the latest state-of-the-art and subjected to tests.
Checking after
replacement of
electrical
components
According to DIN VDE 0113 part 1 / EN 60204-1, the following must be checked after an
electrical component has been exchanged:
8 Check whether the electrical equipment corresponds to the technical documentation.
8 Check whether the connections of the grounding conductor system are continuous.
8 Perform a functional check.
To Next Page
Loading...
