July 2010 30 – 573
Calling the machine
parameter editors
8 Select the Programming and Editing operating mode.
8 If open: Close the program management by pressing the END button.
8 Call the code number window.
8 Enter the code number and press ENT to confirm.
The active machine parameter list appears on the screen in the Machine Parameter Programming
mode:
8 Press the END key to exit the MP list.
Pressing the MOD key while the program manager is open calls the interface settings.
If the message "Line is write-protected" is displayed when trying to edit a machine-
parameter value, individual machine parameters or the complete MP list is protected against
editing.
The machine manufacturer has defined an own MP code number. --> Please contact your
machine manufacturer!
To Next Page
Loading...
