HEIDENHAIN ITNC 530 - Page 590

30 – 590 HEIDENHAIN Service Manual iTNC 530
MP1240.x Max. permissible axis-specific jerk at curvature changes for single filter
Input: 0.1 to 1000.0 [m/s³]
340 490-01
PLC
RUN
MP1241.x Max. permissible axis-specific jerk at curvature changes for double filter
Input: 0.1 to 1000.0 [m/s³]
340 490-01
PLC
RUN
MP1242.x Max. permissible axis-specific jerk at curvature changes for HSC filter
Input: 0.1 to 1000.0 [m/s³]
340 490-01
PLC
RUN
MP1243.x Max. permissible axis-specific jerk at curvature changes for advanced HSC filter
Input: 0.1 to 1000.0 [m/s³]
340 490-01
PLC
RUN
MP1250.x Factor for axis-specific jerk at corners at rapid traverse (from value in MP123x.x)
Input: 0.0000 to 30.0000
1: No change at rapid traverse
340 490-02
PLC
RUN
MP1262 Only CC 424(B): Filter order used for HSC filter
Input: 0 to 31 [filter order]
31: Default
340 490-02
PLC
RUN
MP1263 Only CC 424(B): Filter order used for advanced HSC filter
Input: 0 to 31 [filter order]
31: Default
340 490-02
PLC
RUN
MP1290 Only with option #40: Maximum angle tolerance for DCM (Dynamic Collision
Monitoring)
Input: 0.0000 to 30.0000 [°]
3: Default
340 490-02
PLC
RUN
MP1292 Only with option #40: Manual oversize for DCM (Dynamic Collision Monitoring)
Input: 0 to 1.000 [mm]
0: Default
340 490-02
PLC
RUN
MP1320 Direction for traversing the reference marks
Format: %xxxxxxxxxxxxxx
Input: Bits 0 to 13 represent axes 1 to 14
0: Positive
1: Negative
PLC
RUN
MP1330.x Velocity for traversing the reference marks
Input: 80 to 300 000 [mm/min]
PLC
RUN
MP1331.x Velocity for leaving the reference mark end position for axes 1 to 9 (only for rotary
encoders MP1350 = 2)
Input: 10 to 300 000 [mm/min]
PLC
RUN
MP1340.x Sequence for traversing the reference marks
Input: 0: No evaluation of reference marks
1 to 14: Axes 1 to 14
PLC
RUN
REF
MP Function and input SW version
and
behavior