HEIDENHAIN ITNC 530 - Page 619

July 2010 30 – 619
MP7245 Disabling auxiliary cycles
Input: 0: Auxiliary cycles disabled
1: Auxiliary cycles permitted
PLC
RUN
MP7246 Machine parameter with multiple function
Input: %xxxx
Bit 0 – Paraxial positioning blocks
0: Permitted
1: Locked
Bit 1 – Clear with DEL key
0: Does not need confirmation
1: Must confirm via soft key
Bit 2 – Tool usage file
0: Do not generate
1: Generate
Bit 3 – Settings file for AFC
0: Do not generate
1: Generate
Bit 4 – ASCII file for machining time per NC block
0: Do not create ASCII file for machining time per NC block
1: Create ASCII file for machining time per NC block
PLC
RUN
340 490-04
MP7251 Number of global Q parameters starting from Q99 (up to Q60) that are transferred from
the OEM cycle to the calling program.
Input: 0 to 40
PLC
RUN
MP7260 Number of tools in the tool table
MP7260 can also be overwritten by the PLC and the LSV2 protocol.
Input: 0 to 30 000
CN123
340 490-03
MP7261.0-7 Number of pockets in the tool magazine 1 to 8
MP7261 can also be overwritten by the PLC and the LSV2 protocol.
Input: 0 to 9999
CN123
340 490-05
MP7262 Maximum tool index number for indexed tools
MP7262 can also be overwritten by the PLC and the LSV2 protocol.
Input: 0 to 9
CN123
340490-03
MP7263 Pocket table
MP7263 can also be overwritten by the PLC and the LSV2 protocol.
Format: %xx
Input: Bit 0 –
0: Show POCKET TABLE soft key
1: Hide POCKET TABLE soft key
Bit 1 – Output of the columns for file functions
0: Output only the displayed columns
1: Output all columns
Bit 2 – Show the "Edit ON/OFF" soft key in the pocket table
0: Display soft key
1: Do not display soft key
Bit 3 – Soft keys "Reset pocket table" and "Reset column T"
0: Display soft key
1: Do not display soft key
CN123
340490-05
MP Function and input SW version
and
behavior