9 – 94 HEIDENHAIN Service Manual iTNC 530
Calling the drive
information
Up to and including NC software version 34049x-03:
8 Shut down and switch off the machine.
8 Switch on the machine; do not confirm the Power interrupted message.
8 Select the Programming and Editing mode of operation
(the program manager must not be open).
8 Press the MOD key.
8 Press the DIAGNOSIS soft key.
8 Press the DRIVE DIAGNOSIS soft key. --> A new window opens:
The DRIVE DIAGNOSIS soft key is only visible until the Power interrupted is confirmed.
To Next Page
Loading...
