January 2012 6.20 Commissioning 1109
1. Checking the
counting direction
To check the counting direction of the position measuring system, proceed as
follows:
Switch on the machine.
Select the following operating mode without crossing over the reference
marks:
Manual Operation
Switch to the Oscilloscope mode of operation.
Set the following values in the oscilloscope by pressing the SELECTION soft
key:
Display mode: YT
Sampling time: IPO clock
Channel 1: Analog
Channel 2: v nom
Channel 3: v act
Trigger: Free run
Press the OSCI soft key to switch to the curve representation.
Press the START soft key to start recording.
Press the axis-direction key of each axis to be checked.
Press the STOP soft key to stop recording.
Settings in the configuration editor:
Axes
ParameterSets
[Key for parameter set]
CfgAxisHardware
signCorrActualVal
signCorrNominalVal
Incorrect algebraic sign
To Next Page
Loading...
