January 2012 7.4 Switching the Control On/Off 1315
Customer-specific
logo
While the control is starting, a customer-specific company logo can be
displayed instead of the HEIDENHAIN logo. The logo must be a bitmap file
(*.BMP) with a picture size of 1024 x 768 pixels.
Path and file name of bitmap file:
PLC:\resource\startup_1024x768.bmp
Starting the control
with empty PLC
partition
During start-up, machine parameters are automatically transferred from the
PLC partition. If the PLC partition does not contain any data, however (e.g. loss
of data, partition inadvertently erased or initial operation), the control cannot
be started.
If this occurs, you can access the control via TNCremoNT. This enables you to
restore a PLC partition that has been backed up before.
Example:
To Next Page
Loading...
