HEIDENHAIN MANUALPLUS 620 - Page 1320

1320 HEIDENHAIN Technical Manual MANUALplus 620
Machine
parameters
MP_shutdownOnConfig
Behavior when RESET configuration data is changed
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: RESTART
The control is shut down and then restarted.
TERMINATE
The control is shut down, but the operating system remains
active.
SHUTDOWN
The control and the operating system are shut down.
POWEROFF
The control and the operating system are shut down. If a PLC
output is entered in MP_powerOffPort, it will be set after
shutdown.
Default: RESTART
Access: LEVEL3
Reaction: NOTHING
MP_shutdownOnError
Behavior when RESET errors are acknowledged
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: RESTART
The control is shut down and then restarted.
TERMINATE
The control is shut down, but the operating system remains
active.
SHUTDOWN
The control and the operating system are shut down.
POWEROFF
The control and the operating system are shut down. If a PLC
output is entered in MP_powerOffPort, it will be set after
shutdown.
Default: RESTART
Access: LEVEL3
Reaction: NOTHING