January 2012 7.6 Electronic Handwheel 1335
Evaluation of
handwheel pulses
Define the evaluation of the handwheel pulses in the following parameters:
MP_incrPerRevol: Number of increments per handwheel revolution
MP_rasterPerRevol: Detent steps per handwheel revolution (only for
handwheels with detent)
MP_countDir: Direction for handwheel input
MP_incrPerRevol
Increments per handwheel revolution
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0 to max. value
0: Standard value for HEIDENHAIN handwheel (20 000
increments)
Default: 0
Access: LEVEL3
Reaction: RUN
MP_rasterPerRevol
Detent steps per handwheel revolution
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0 to max. value
0: Handwheel without detent
Default: 0
Access: LEVEL3
Reaction: RUN
MP_countDir
Counting direction for handwheel
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: positive
Positive counting direction
negative
Negative counting direction
Default: positive
Access: LEVEL3
Reaction: RUN
To Next Page
Loading...
