HEIDENHAIN MANUALPLUS 620 - Page 422

422 HEIDENHAIN Technical Manual MANUALplus 620
CfgShutDown
Behavior when exiting control operation
shutdownOnConfig
101601
MP4040
(optional parameter)
Behavior when RESET configuration data is
changed
Specifies the MANUALplus 620’s reaction to a
change that requires a RESET.
Note:
If no value is entered for this parameter (icon
appears dimmed), no automatic reset will be
performed. In this case you start the reset by soft
key.
Format: Selection menu
Input:
 RESTART:
Control shuts down and restarts
 TERMINATE:
Control shuts down. For controls with additional
Windows operating system:
Windows keeps running.
 SHUTDOWN:
Control shuts down. For controls with additional
Windows operating system:
Windows shuts down.
 POWEROFF:
Shut down the control
Default: RESTART
PLC/Pgm
run is
locked
LEVEL1
1320
shutdownOnError
101602
MP4040
Behavior when RESET errors are
acknowledged
Specifies the MANUALplus 620’s behavior when
a RESET error is acknowledged.
Format: Selection menu
Input: see MP_shutdownOnConfig
Default: RESTART
PLC/Pgm
run is
locked
LEVEL1
1320
shutdownOnUser
101603
MP4040
Behavior when the MANUALplus 620 is shut
down by soft key
Specifies the MANUALplus 620’s behavior when
it is shut down by soft key.
Format: Selection menu
Input: see MP_shutdownOnConfig
Default: TERMINATE
PLC/Pgm
run is
locked
LEVEL1
1321
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page