HEIDENHAIN MANUALPLUS 620 - Page 423

January 2012 4.10 List of Machine Parameters 423
shutdownOnOem
101604
MP4040
Behavior when PLC module 9279 is called
Specifies the MANUALplus 620's behavior when
the OEM shuts down the control using PLC
module 9279.
Format: Selection menu
Input: see MP_shutdownOnConfig
Default: TERMINATE
PLC/Pgm
run is
locked
LEVEL1
1321
maxTermTime
101605
(optional parameter)
Delay time until control is shut down
Defines the time before the process is
terminated.
Format: Numerical value
Input: 0 to 1000 [s]
Default: 0 [s]
PLC/Pgm
run is
locked
LEVEL1
1322
powerOffDevice
101608
(optional parameter)
Number of the device in the HSCI chain
System with HSCI interface:
Enter the number of the device in the HSCI chain
(= bus address) at which the control is to set a
PLC output after shutting down in order to switch
off the power supply, for example.
System without HSCI interface:
Do not assign the parameter.
Format: Numerical value
Input: 0 to 20
Default:0
PLC/Pgm
run is
locked
LEVEL1
1322
powerOffSlot
101609
(optional parameter)
Number of the PL module in the HSCI device
System with HSCI interface:
Enter the number of the PL module on the HSCI
PL at which a PLC output is to be set after
shutting down.
System without HSCI interface:
Do not assign the parameter.
Format: Numerical value
Input: 0 to 8
Default: 0
PLC/Pgm
run is
locked
LEVEL1
1322
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page