HEIDENHAIN MANUALPLUS 620 - Page 457

January 2012 4.10 List of Machine Parameters 457
CfgPlcOverrideDev
Configuration of sources for override values;
Define the hardware input of the potentiometers and the evaluation.
[Key name of override device]
e.g. potentiometerF, potentiometerS, etc.
source
104301
Selection of configurable source for override
values
Format: Selection menu
Input:
 OVR1:
Potentiometer 1
Feed-rate override input F on the rear side of the
TE.
 OVR2:
Potentiometer 2
Spindle-override input S on the rear side of the
TE.
 OVR3:
Potentiometer 3
Rapid-traverse override input E on the rear side
of the TE.
 KEY:
Group of keys
Default: OVR1
RESET
LEVEL3
1353
mop
104304
Enter the key name of the machine operating
panel on which the override source is located
Defines the operating panel on which the override
source is located.
Format: Selection menu
Input: Key name from CfgPlcMop
RESET
LEVEL3
1353
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page