HEIDENHAIN MANUALPLUS 620 - Page 532

532 HEIDENHAIN Technical Manual MANUALplus 620
encoderResistor
400208
(optional parameter)
Terminating resistor of position-encoder input
for handwheel
Format: Selection menu
Input:
 without:
Without terminating resistor
 120 ohms:
With terminating resistor
Default: without
PLC/Pgm
run is
locked
LEVEL3
1341
decToSoftLimit
400209
(optional parameter)
Braking ramp for handwheel movement to
software limit switch
(MP_swLimitSwitchPos or
MP_swLimitSwitchNeg)
Format: Numerical value
Input: Braking ramp [m/s
2
] or
[1000°/s
2
] for rotary axes
Default: 0
PLC/Pgm
run is
locked
LEVEL3
597 110-03
1343
CfgFeedLimits
Define the axis velocities and acceleration;
For rotary axes and spindles, the velocity is specified in [°/min] and the acceleration in
[1000°/s
2
].
minFeed
400301
MP3240.1
Applies only to the main spindle: minimum
spindle speed
Format: Numerical value
Input: 0.0 to 36 000 000.0 [°/min]
Default: 0 [°/min]
Allowed in
strobe
LEVEL3
831
maxFeed
400302
MP1010,
MP3515
Maximum axis feed rate (rapid traverse) or
maximum spindle speed
Format: Numerical value
Input: 0.0 to 36 000 000.0 [mm/min] or
[°/min]
Default: 16 000.2 [mm/min] or [°/min]
Allowed in
strobe
LEVEL3
831
rapidFeed
400303
MP1010
Rapid traverse in manual mode
Maximum axis feed rate in manual mode, using
the rapid traverse key. For rotary axes and
spindles, the velocity is specified in [°/min].
Format: Numerical value
Input: 0.0 to 36 000 000.0 [mm/min] or
[°/min]
Default: 4 999.98 [mm/min]
Allowed in
strobe
LEVEL3
832
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page