HEIDENHAIN MANUALPLUS 620 - Page 538

538 HEIDENHAIN Technical Manual MANUALplus 620
refFeedLow
400406
MP1330
Low speed when finding the reference mark
Depending on MP_refType, this low speed is
used for finding the reference mark.
Format: Numerical value
Input: 0.0 to 36 000 000.0 [mm/min]
Default: 600.0 [mm/min]
RUN
LEVEL3
799
refFeedHigh
400407
MP1330
High speed when finding the reference mark
Depending on MP_refType, this high speed is
used for finding the reference mark.
Format: Numerical value
Input: 0.0 to 36 000 000.0 [mm/min]
Default: 1200.0 [mm/min]
RUN
LEVEL3
799
refDirection
400408
MP1320
Traversing direction for finding the reference
mark
Format: Selection menu
Input:
 positive:
Positive traverse direction
 negative:
Negative traverse direction
Default: Negative
RUN
LEVEL3
799
moveAfterRef
400409
Activate movement after finding the reference
mark
Format: Selection menu
Input:
 on:
Positioning after reference-mark traverse is
active
 off:
No positioning after reference-mark traverse
Default: off
RUN
LEVEL3
806
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page