HEIDENHAIN ND 1200 - V2.16 - Presetting the Datum

ND 1200 QUADRA-CHEK 37
1.3 Preparing to Measure
Presetting the datum
Datums can be zeroed or preset. This example creates a preset
reference datum from a point feature.
U With the datum point highlighted in the feature list,
press the DATUM key if necessary to select the
desired datum in the upper right corner of the screen.
U Press MENU/EXTRA/PRESET/ENTER to display the
preset screen.
U Press the desired AXIS key and enter the preset value
for the axis.
U Press another AXIS key if desired and enter the preset
value for that axis.
U Press the FINISH key to preset the datum to the
specified values.
PRESET Selected from EXTRA menu Preset values are entered Point is preset as datum