42 1 Operation
1.4 Measuring Part Features
Measuring points
Points are the simplest features to measure. Only one point is required
to define the location of a point. A maximum of 100 points can be
probed and will be averaged by the system to measure a single point.
U Press the POINT MEASUREMENT key. The Probe
Point screen will be displayed. Press the key twice to
measure a series of points using auto repeat.
U Move the stage to position the crosshairs over the
desired point location and press the ENTER key.
U Press the FINISH key to complete the measurement.
The point position will be shown and the point feature
will be added to the feature list.
A point is probed on the part
The point position is shown and the point feature is
added to the feature list
To Next Page
Loading...
