48 1 Operation
1.5 Creating Part Features
Example of creating a feature
In this example, a circle is created:
U Press the feature MEASUREMENT key. In this
example, the CIRCLE MEASUREMENT key is
pressed and the Probe Circle screen is displayed.
U Press the CREATE soft key to display the Create data
entry screen. In this example, the Create Circle
screen is displayed.
U Enter the desired feature parameters. In this example,
the circle position and diameter (or radius) values are
entered into the X, Y, Z and D data fields.
U Press the FINISH key. The new feature will be shown
on the screen and added to the feature list.
CIRCLE MEASUREMENT key is pressed Circle position and diameter values are
entered
New circle is shown in the feature list
To Next Page
Loading...
