50 1 Operation
1.6 Constructing Part Features
Example of constructing a feature
In this example, a new point feature is constructed from two parent
circle features:
U Press the feature MEASUREMENT key corresponding to the
feature you want to construct. In this example, the POINT
MEASUREMENT key is pressed.
U Press the CONSTR soft key or press the up ARROW CURSOR key
to highlight the last feature in the feature list. If the last feature in
the feature list will not be one of the parent features, press the up
ARROW CURSOR key until the first parent feature is highlighted. In
this example, the first parent circle feature is at the bottom of the
feature list.
U Press the ENTER key to select the highlighted feature. A checkmark
will appear at the feature location in the list.
U Continue highlighting and then selecting features until all the
required parent features are selected. In this example, the second
circle feature is highlighted and selected.
U Press the FINISH key to construct the new feature. The new feature
will be added to the feature list. In this example, a new point feature
is shown at the bottom of the feature list.
POINT MEASUREMENT key is pressed First circle feature is highlighted First circle feature is selected as a parent
feature
Second circle feature is highlighted Second circle feature is selected as a
parent feature
FINISH key is pressed to create new
point feature
To Next Page
Loading...
