ND 1200 QUADRA-CHEK 57
1.7 Tolerancing
U Enter the desired nominal and tolerance values into the data fields
provided. In this example of circle form tolerance, only the
roundness tolerance field is provided, and a tolerance of 0.15 is
entered.
U Press the FINISH key to display the tolerance result. The tolerance
and actual values will be displayed. In this example, the tolerance
value was greater than the actual value and the tolerance passed. A
checkmark is shown to indicate a passed test.
U Press the FINISH key again to return to the DRO screen. The
checkmark is shown again in the TOL soft key box.
The form tolerance is entered The FINISH soft key is pressed to display
the tolerance test result
The FINISH key is pressed to return to
the DRO screen
To Next Page
Loading...
