88 2 Installation and Specifications
2.3 Software setup
Order of setup
The ND 1200 setup software is contained on up to 18 screens,
depending on the hardware configuration. It is possible that not all the
setup screens described in this chapter are active in your system.
Disregard screen descriptions that do not apply to your ND 1200.
The initial ND 1200 setup tasks should be performed in the order listed
here. Instructions are presented in this order on subsequent pages.
The additional setup tasks can be performed in any order.
ND 1200 setup configurations can be saved on USB drives
Initial setup tasks Setup screens
1: Language selection and product version information About
2: Supervisor password entry and program unlocking Supervisor
3: Encoder configuration Encoders and Misc
4. Loading settings files and startup screens (instead of manual setup) Supervisor
5: Optical edge detection setup (optional) Misc screen and Edge soft key menu
6: Stage squareness calibration Squareness
7: Error correction LEC, SLEC or NLEC screen
8: Measurement scaling for parts that expand or shrink Scale factor
9: Measurement configuration Measure
10: Display formatting Display
Remaining setup tasks Setup screens
Hot key assignments Hot keys
Print formatting Print and Form characters screens
RS-232 Port configuration RS-232
USB port configuration USB
Audio configuration Sounds
Key repeat delay Misc
Time and date Clock
Saving settings Setup screens
Saving settings files and ND 1200 programs Supervisor
To Next Page
Loading...
